Guantong feeder accessories: common problems in the application of automatic feeder

GuanTong feeder parts, mechanical equipment application process will make the mechanical equipment internal parts lead to wear out and other problems, in order to better mechanical equipment characteristics and mechanical equipment consideration, the maintenance of the feeder should pay attention to the following six points.
 
Guantong feeding machine accessories, mechanical equipment application process will cause the internal parts of mechanical equipment wear problems,
 
Frequently Asked Questions in Application of Automatic Feeder:
 
1, crown through feeding machine accessories, roller transmission gear part, coating the transmission gear with unsalted butter and fill and remove the oil.
 
2. Whether there is waste between rollers and dirty things between transmission gears.
 
3, GuanTong feeding machine accessories, feeding roller is not good flatness.
 
4. Whether the screws and screw caps between the organizations of the feeding machine are loose.
 
5, Guantong feeder accessories, the actual operation of the control panel of the power switch and display is not abnormal.
 
6, each part is not damaged deformation and other abnormal conditions.
 
Crown feeder accessories, ensure mold gap mold shell gap is blunt needle into the upper die, on both sides of the gap, the sum of it related to thickness, material and stamping die design, suitable for mold shell gap, to ensure the excellent quality of punching machine, reduce the burrs and collapse, maintain plate leveling, reasonable avoid cutting materials, increase the service life of the mold shell. The automatic feeder can judge whether the mold shell gap is suitable according to the condition of stamping die waste. If the gap is too large, the waste will appear not smooth wave cracking surface and small bright surface. The larger the gap is, the larger the Angle of view between the cracking surface and the bright surface will be, and the rolling and cracking will occur when punching machine, and even a thin edge bulge will appear. On the contrary, if the gap is too small, the waste will appear small Angle crack surface and large bright surface. When playing slot, step, the part of the stamping die such as cutting, lateral force will make blunt needle migration and lead to unilateral gap is too small, sometimes edge offset communication meeting scratch on the mould, lead to die around quickly worn, stamping die, die bei to gap crack surface and the same bright perspective of waste, and overlap each other, so can make cold blunt pressure, flash or punching machine.
 
Guantong feeding machine accessories, mechanical equipment application process will cause the internal parts of mechanical equipment wear problems,
 
Crown feeder accessories, reasonable grinding can be increased if the product could the mold shell artifacts appear too much burrs or stamping die cause abnormal noise, the likelihood is passivation of mold shell, numerical control machine feeder inspection blunt needle and the upper die, when its edge grinding bad cause arc with a ca. 0.11 mm, you need to grinding, practice shows that often carry out a small amount of grinding not until to grinding and grinding, not only can maintain the stability of the workpiece quality, reducing the pressure of cold punching, and can make the mold shell over double service life.

Related recommendations